Company Profile

Contact Us

ByTune Electronics Co.,Ltd
Add:C building New-generation Park 28 district Ban'an, ShenZhen, Guangdong
Tel:+86-755-29642158
Fax:+86-755-23503855
Ph:+8618676706981
E-mail:sales@btcncmachining.com

    CNC Turning.jpg

    1.jpg3.jpg


    Milling is a cutting process that uses a milling cutter to remove material from the surface of a workpiece. The milling cutter is a rotary cutting tool, often with multiple cutting points. As opposed to drilling, where the tool is advanced along its rotation axis, the cutter in milling is usually moved perpendicular to its axis so that cutting occurs on the circumference of the cutter. As the milling cutter enters the workpiece, the cutting edges (flutes or teeth) of the tool repeatedly cut into and exit from the material, shaving off chips (swarf) from the workpiece with each pass. The cutting action is shear deformation; material is pushed off the workpiece in tiny clumps that hang together to a greater or lesser extent (depending on the material) to form chips. This makes metal cutting somewhat different (in its mechanics) from slicing softer materials with a blade.

    Manual Milling.jpg

    The milling process removes material by performing many separate, small cuts. This is accomplished by using a cutter with many teeth, spinning the cutter at high speed, or advancing the material through the cutter slowly; most often it is some combination of these three approaches. The speeds and feeds used are varied to suit a combination of variables. The speed at which the piece advances through the cutter is called feed rate, or just feed; it is most often measured in length of material per full revolution of the cutter.

    There are two major classes of milling process:

    In face milling, the cutting action occurs primarily at the end corners of the milling cutter. Face milling is used to cut flat surfaces (faces) into the workpiece, or to cut flat-bottomed cavities.

    In peripheral milling, the cutting action occurs primarily along the circumference of the cutter, so that the cross section of the milled surface ends up receiving the shape of the cutter. In this case the blades of the cutter can be seen as scooping out material from the work piece. Peripheral milling is well suited to the cutting of deep slots, threads, and gear teeth.

    图片15.jpg

    And ByTune have two kinds of typical Milling machines: 

    Vertical milling machine.

    Horizontal milling machine. 

    With these machines, it is far quicker and flexible for us to process prototypes. Contact us to find out how ByTune can help with your complete manual milling needs. Our experienced staff is ready to help you.